Bending Wands?

[jeffzee]

Any of you guys have a way of bending wands without kinking them? I have an 18ft extendable pole that has about a 15inch wand that attaches on the end of it, it is almost straight right now but i want to curve it down a bit so i not blasting water up at my siding, want to blast kinda straight on or down a bit. A gutter cleaner attachment has to much curve, any ideas?

Thanks

 

[Larry B]

Depending on what it is made out of it shouldn't be a problem. I bend them all the time. If you want a gentle curve just bend a little in different areas.

 

[PressurePros]

Look for a place that has a Mandrel bender. My PW'ing supply house has one. You can also go to a cycle shop, body shop or exhaust specialist.

 

[vandiesel99]

Fill the wand tightly with sand, heat the bend point slightly then use a bench vise to bend it.