Search results

  1. S

    Newby Hood cleaning

    Hello, I located in Atlanta, Georgia and I'm trying to get into the hood cleaning business. Do you need to be a certified hood cleaner? If so, can anyone recommend any training facilities in which, I can obtain such a certification?
  2. S

    Pressure washer damage

    Hello, I have a big job in which we will have to rent a hydraulic lift to clean a 150 ft Church. We will be using 3000PSI Hotsy units @4gpm and I wanted to know if there could be any potential damage to the washers considering that the units will cleaning at such great altitudes. I have heard...
  3. S

    Car lots

    Hello, I am interested in fleet wash business and I wanted to know what is the going rate for each vehicle on a typical car lot which consist of approximately 100 vehicles. How much are you guys charging for each type of vehicle and what type of service is provided (Are you just spraying the...
  4. S

    Fleet

    Hello, we're considering the fleet business and we wanted to know how should we charge for cars,trailers,commercial vans and suvs etc.. Any help would be greatly appreciated!!
  5. S

    X-Jet

    What do everyone think about the Ex-Jet? I recently used the Ex-jet for the first time and it worked well but I didn't exactly get the results that I was hoping for, considering that my chemicals are being diluted with more water than usual. Maybe I need to strengthen my chemical mixture. Any...
  6. S

    concrete cleaning

    Hello, what can we use to clean a concrete building without having to get directly ontop of the surface with the water pressure. We are using 3000 psi hot water unit and we are equiped with the ex-jet. We are looking for a solution that can cut that dirt with little pressure. Any suggestions...
  7. S

    Pressurewashing Commercial Building

    Hello, we need to know how to charge for pressurewashing a 48,000 sq.ft. concrete building using hot water units. The building is not too dirty but it is a very large job. It's about 18 feet tall and we will have a boom lift to reach the elevated areas. If anyone can offer any suggestions on...
  8. S

    wood fence

    How should I charge to pressurewash and seal a pinewood fence?
  9. S

    Question about decks in Atlanta, GA

    Hey, typically how long should you allow a deck to dry after pressurewashing, before applying the sealant? The weather is about 90 degrees and sunny. Thanks
  10. S

    Pressurewashing decks

    Hello! I have a 100 sq.ft deck to pressurewash, seal and stain and need to how much should I charge. Thanks
Top