Quick Coupling Unloader

[Bill B]

Have had to remove my unloader 3 times in past week. Currently hard piped. Any reason I couldn't put 3/8" quick couplings on the inlet for quicker removal? Then all I would need to do is unscrew hose clamp on bypass line.

 

[ron]

ron p

why do you need to keep taking the unloader off?
i would use stainless steel IF you can do it.
i dont about that.

 

[Mark]

I have seen a few people place a 3/8" QC on the unloader,
inlet and outlet.

 

[Bill B]

Based on your responses (i.e. no one is saying this is a dumb idea) I will try out the next time I pull the unloader. Thanks!

 

[Larry L.]

Bill,I do not see nothing dumb about,when I ran unloaders I had them QC,even on the bypass line and where it goes and comes out of the burner.